Analysis of the safety belt conveyor machinery operation

Belt conveyor machinery safety procedures are as follows:
1 Several mechanical 90 degree turn conveyor running series, we should begin the discharge end, the sequence starts. All normal operation only after the feeding.
2 Run the tape deviation phenomenon occurs, you should stop adjustment shall not be reluctant to use, so as not to wear edges and increase the load.
3. The working environment and the material was sent to a temperature not higher than 50 ℃ and below -10 ℃. Shall not be transported with a pH of oils and organic solvents constituent materials.
4 conveyor prohibit pedestrians or by people.
5 must be stopped before stopping feeding, unloading and other material on the belt to make deposits before parking.
6 conveyor motor must be well insulated. Mobile chain conveyor cables do not Luanla and dragging. Motor must be grounded reliably.
7 belt slipping a hand to pull the belt is strictly prohibited, so as to avoid accidents.
8 belt conveyor installation method should be required to install a fixed basis. Mobile conveyor official before running wheels should live or with a triangular wedge brakes stopped in order to avoid moving around the work place, a number of conveyor parallel operation, the machine and the machine between the machine and the wall should be between

One meter channels.
9. Transportation machinery must be inspected prior to use part of the operation, the tape fastener and bearing device is normal, protective equipment is complete. Tape tensioner degrees required before starting to adjust to the appropriate level.
10 no-load belt conveyor machinery should start. Etc. operating normally before feeding. Prohibit driving after the first feeding.