Food conveyor line maintenance 5 reciprocity

Which Food conveyor development is immeasurable. Food conveyor is convenient , but in order to protect our lives and property, or to be cautious strict accordance with the

production requirements to operate.
Transmission line equipment in the food or in the production line staff install conveyor equipment , often for some jobs often malfunction can not find the crux of it is not

understood how to troubleshoot and even delay the production losses to the enterprise . Below we talk about the food

Product conveying line at runtime , transmission lines belt deviation causes and treatment methods, and Gravity roller conveyor maintenance.
Food conveyor has long been widely used in coal, grain, flour mills and other industries in the conveyor , not only easy to manage but also can be transported in bulk (

lightweight ) of the material , but also to transport bags ( weight -based ) materials.
Food conveyor running in production which , slipping for many reasons , the following we talk often seen in the job as well as ways to deal with :
Method 1: Food conveying line belt load is too large , the load exceeds the capacity of the motor can , therefore slip. At this point should be to reduce the amount of

transported material transport conveyor itself or increase the loading capacity .
Method two : food conveyor line to start too fast and cause slipping. At this point should slow start or jog again and restart twice , it can overcome the slip phenomenon.
Method three: initial tension is too small. The reason is belt tension when leaving the drum is not enough, caused by belt slippage . At this point processing method is to

adjust the tensioning device , increase the initial tension .
Method four : It is not rotating roller bearing damage . May be due to the accumulation of too much dust or did not timely maintenance and replacement has been severely worn

parts and rotation is not flexible , resulting in increased resistance and slip.
Method five : is the drive roller and the conveyor belt is not caused by the friction between the skidding . Most likely cause of the conveyor belt with water or humid operating

environment . At this point in the drum should add a little rosin powder.