2013年9月4日星期三

Belt routine maintenance and periodic maintenance

Installing centerline is not straight . However, if the rack Telescopic belt conveyor rope vertical and horizontal level is not . Semi- hanging belt who woo wood horizontal spacing changes , or the word

wood into his inward tilting belt deviation , etc. are bit serious . This occurs , only the down regulation of horizontal distance down. Longitudinal onwards

Volt is generally not affect the deviation . Of course, the ups and downs too big, too powerful and easy belt surge deviation .
Tape joints are not straight . That belt buckle crooked nails or tape bandwidth is not cut at right angles with the belt tension by uneven . This joint operation run time to get

there , where the deviation occurs . When this happens, with cutting down Guppy positive , heavy nail .
Extendable conveyor roller centerline Centerline not straight with consultation , installed crooked . This is mainly because the rack is not properly installed . This occurs despite

acres to adjust roller bearings front and rear position , but the distance is limited, must be rack mounted crooked rework reloading . Head wave Jianduxiangzhong

Heart must be asked with a soft tail roller center line .

没有评论:

发表评论