Vibrating conveyor trough structure

Vibrating conveyor trough generally made of steel plates, with its width and height to the required transmission capacity to adapt its length is based on the requirements of the

material transported in the distance. Tank with a spring or chain link with hinged support or suspension, by the driving means to produce vibrations.
(1) vibrating conveyor trough cross-section
Straight sidewalls flat tank from a single piece of steel from repression, for general transportation; oblique sidewall flat tank. When conveying hot materials can be material

on the side to minimize friction and deformation; slotted wall tank. Tank body stiffness and have a replacement flat; semicircular or elliptical

Tank. For conveying relatively thin, circular sheet materials (such as food, can lid, caps, etc.); straight walls with flat lid flat tank. Dust-proof and water proof, to make

the material being transported does not hit the top cover, so to limit the thickness of the material in the tank; tubular tank. Use for

Conveying or feeding seals required. The majority of the material being transported, the adoption of such a tank must not be above the centerline of materials; tank with an

arched roof, flat roof tank with the same, but its more rigid; V-shaped trough. Transmission capacity is very low for the occasion, you can continuously

Places to concentrate, were thin remove particulate material stream.
(2) vibrating conveyor trough material selection
For overloaded conveyor trough to obtain strong solid. The tank can be low carbon steel, wear-resistant steel, stainless steel or other special alloy steel, according to

requirements in a wide range of materials can be selected. Tank lining these materials may also be used, may also rubber, plastic

Or ceramic.
Tank lining material according to the performance of the material being transported and economic factors to select, size 25 or 50mm for less highly abrasive materials, high-

density alumina porcelain lined, bonded with epoxy resin The flat on the tank, this ceramic lining has been successfully used to

Transport rolling mill coke and other materials. There are also polyurethane plastic lining, this lining has been used to transport wet, thin, abrasive materials.
Other commonly used in the lining material is 304 stainless steel, it is particularly suitable for conveying corrosive and abrasive materials. Material in the feeder or conveyor

sliding action on the stainless steel worn very smooth, you can prevent the accumulation of material, but also thereby extending its life. When the need to

Vibrating conveyor to control the noise level within the allowable range in the standard, and sometimes the body located in the groove in addition to the lining, but also to

adjust the conveyor speed, inclination and length of stroke.
(3) vibrating conveyor trough structure
Vibrating conveyor trough is generally forming or pressure plate welded structure, depending on the load conditions, the groove width, transportation of materials

characteristics, expected degree of wear of the tank and replacement requirements to choose. Power Roller Conveyor trough body frame designed with beams, beams fixed on the solid

side

The longitudinal groove in order to ensure that the various operating conditions of the size and shape of the tank constant.
Pressure molded tank with a single piece of extruded steel bottom and two sides, which ensures that the powder material does not leak. This tank lining, especially the use of

thin stainless steel plate forming the lining, can be used in flat bottom ensures easy replacement.
Plate welded tank from the bottom and side panels three steel plates. The maximum width of the tank can be spliced ​​to 3650mm. Between the sides and bottom with a continuous weld

seams. This construction can be equipped with flat lining, the lining can be quickly and easily replaced.