Conveyor feed chute and discharge chute introduction

Since the unit at different heights and materials by virtue of its own gravity chute tilt slide from one device to another device. Sent from the device material chute called the

"next chute" or "out of the chute."; Send the material into the chute device called a "feed chute" or "derivative material

Slot ", actually two kinds chute chute can be the same, because of its different positions, leaving different name.
Belt conveyor feed chute
By supplying materials by conveyor chute to the application which is widely used. The types and uses, including the two most widely used feed chute.
With sieve feed chute allows fine material is formed on a Flexible skatewheel conveyor cushion to absorb the impact of bulk materials on conveyor belts and prevent massive material directly in

contact with the conveyor generated when rolling phenomenon.
Box with plot material feed chute for strong abrasive materials and slower conveyor, chute feed box at the bottom of a plot to absorb the impact of falling material and prevent

the chute being not normal wear and tear, but erosion of more than one material or materials to be transported

The conveyor can not use this chute.
Belt conveyor discharge chute
A typical belt conveyor chute top covering hood can be added, with the roller slide plate edge a sufficient distance in order to capture all the materials. If the material

contains hard, sharp block material, then slip rubber strips installed on the edge of the board is a better approach. Chute must be designed

Material left by the conveyor track to consider, in order to make the material falls inclined chute floor without falling pick up on a Extendable conveyor.
A properly designed chute, the material to be removed to make free and smooth flow of the material generated to avoid accumulation and clogging.