Caesar feed belt conveyor

Caesar feed belt conveyor is a common problem , the reasons are multi-faceted . But the focus is to strengthen the routine care and maintenance .
1 point spread material reproduced reprinted material at the point spread mainly in the fall hoppers, chutes , etc. . If severe overload belt conveyor , belt conveyor chute

gauge damage rubber apron , rubber portable conveyor apron far longer at the material chute plate design material from the belt out of the lead

Slot. The above situation can be in control of the transport capacity , strengthen the maintenance to be resolved on maintenance.
2 Caesar feed concave section concave section belt vacant belt when the interval when the concave radius Plastic belt conveyor of curvature smaller segment will generate vacant belt , then the belt

into the groove circumstances change , because the belt has left the trough idlers , general groove angle becomes smaller, so that part of the material spread out . Therefore ,

in the design

Phase should be possible to count with a larger radius of curvature of the concave section to prevent the occurrence of such situations. As the mobile mechanical loading machine

, stacker-reclaimer machines and equipment in order to shorten the trailer is designed to be recessed section here no arc transition interval, when the degree of belt width is

smaller than the choice easier

Caesar feed .
3 material spreading spreading material of the belt when the deviation when the deviation is due to the two edges of the belt runs the height changes , the high side and the

other side is low, the spreading material from the lower side , the processing method is to adjust belt deviation.